Brookfield CT3 Texture Analyzer Manual de usuario descargar pdf (Pagina 24)

Brookeld Engineering Labs., Inc. Page 24 Manual No. M08-372-C0113

Duringthetesttherunningscreenisseenasshownbelow:

TEST: TENSION

DEFORMATION:XXXX.X mm

LOAD: XXXX.X g

III.25

Deformation and Load will remain live displays during the test. When deformation reaches the

target value, the test stops.

Testresultsareshownonthereportingscreen:

PEAK LOAD: XXX.X g

DEF@PEAK: XXX.X mm

WORK: XXXX.X mJ

FINAL LOAD: XXXX.X g

TEMP: XXX.X F

III.26

Peak load is the maximum load measured during the test. Temperature at peak load is only shown

if temperature probe is used.

Def@Peak is the sample deformation at the peak load. The trigger position is the zero deformation

reference point.

Workistheareaundertheloadcurveandismeasuredinmillijoules.

Final load is the load at the target deformation.

NOTE:Itisnotpossibletoperformtensiontestswiththe100gloadcell.

SURIMI TEST - performs a single compression of a surimi sample until the gel ruptures. The

testresultwillbethedistancethesampledeformedbeforeitrupturedandthepeakloadjustprior

to the rupture. As soon as the rupture occurs the probe retracts to the HOME starting position.

NOTE: ThistestisonlyavailableinCT3instrumentswithloadcellsupto4500gandrm-

ware version 2.0 or higher.

The operator may set the trigger value, correction value and test speed.

TEST: SURIMI

TRIGGER: 5.0 g

CORRECTION: 30 g

SPEED: 1.0 cm/s

III.27

The trigger value is a small load, in grams, measured by the CT3 that indicates the probe is in contact

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Sin comentarios

Brookfield CT3 Texture Analyzer Manual de usuario Pagina 24