Brookfield DV-II+ Programmable Viscometer Manual de usuario descargar pdf (Pagina 33)

Brookfield Engineering Labs., Inc. Page 33 Manual No. M/97-164-F1 102

RUN PGM SLOT#1

PRESS ENTER

Figure 60

Using the UP/DOWN ARROWkeys, select one of the four (4) stored programs. Press the ENTER/

AUTORANGE

key. Any attempt to select a program slot that does not contain a program will result

in a double beep for each key press. When a valid program slot is selected, the screen in Figure 61

is displayed:

PRINT KEY = LIST

ENTER KEY = RUN

Figure 61

At this point, you may elect to print the B.E.V.I.S. program by pressing the PRINT key or start the

program immediately by pressing the ENTER/AUTORANGE key (remember: pressing the MOTOR ON/

OFF/ESCAPE key will stop the current operation and bring you back one menu level). You may elect

to print the program, to confirm the slot choice as correct or simply to have it available later when

reviewing data. If you elect to print the program, you will return to the screen of Figure 60 after the

program is finished printing. Pressing the ENTER/AUTORANGE key exits the screen of Figure 60 and

the program will start running.

On program start, the screen could be any of the screens possible when running a B.E.V.I.S. program.

A typical screen might be:

USE SPINDLE 31

PRESS A KEY

Figure 62

where the operator is instructed to mount a spindle 31 and then press a key to continue. Or you might

see:

SET TEMP TO 100C

PRESS A KEY

Figure 63

followed by:

WAIT TEMP 100C

P1 S00/12 00:14

Figure 64

Here, the B.E.V.I.S. program is waiting for the temperature to reach one hundred (100) °C before it

continues to the next program step. Also displayed is the program number (P1), the step number

and the total program steps (S00/12) and the elapsed time since the program (or step) began (00:14).

While in this “wait state” you can press the OPTIONS/TAB key to see the viscometer default screen

in Figure 65; the PGM will be flashing.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 74 75

Sin comentarios

Brookfield DV-II+ Programmable Viscometer Manual de usuario Pagina 33