
BrookeldEngineeringLabs.,Inc. Page23 ManualNo.M08-218-B0212
Menu Handling
Since the LCD of the R/S CPS+ Rheometer cannot show all menu items simultaneously, only three
entries are displayed on the menu at a time. Arrows (>) on the right side of the display indicate
that there are more menu entries. The arrow on the 2nd line indicates there are more menu entries
above and the arrow on the 4th line indicates more menu entries below.
The currently active (but not yet selected) entry is marked by a blinking eld (cursor) on the left
side of the LCD.
Example:
MAIN-Menu
Thermostat
-Single Measurement
-Program Measurement >
This menu contains
additional entries
Active entry: press
OK to select
Using the
and
keys, you can move the cursor up and down in the menu until the desired
menu entry is reached.
Note: If there are more menu entries in the menu when you have reached the end of the display,
the next part of menu will be opened automatically (scrolling).
You can “start” the menu entry by pressing the
OK
key, as well as open the related sub-menu.
If you are in a submenu and wish to return to the upper menu, press the
ST
key.
VI.3 SelectingfromLists
The same keyboard and display functions that are in the menu apply if you have to select a pre-
existing entry from a list. Selection from a list is required for the following:
• Select a measuring system for measurement, e.g.in “Single measurement” or “Edit Program”
• Select pre-set values for measurement, e.g. in “Single measurement” or “Edit Program”
• Select a program or a measuring system you want to edit in “Edit Program” and “Measur-
ing Systems”
• Answer a request “YES” ↔ “NO”.
• Select the program to be started in “Run Program”
The
and
keys move the cursor up and down the list.
The
OK
key selects the entry, the
ST
key stops the selection from the list (only if possible).
Comentarios a estos manuales