Brookfield R/S CPS Rheometer Manual de usuario Pagina 54

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 62
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 53
BrookeldEngineeringLabs.,Inc. Page54 ManualNo.M08-218-B0212
R/S-CPS+ Cone/Plate Rheometer with appropriate cables
Temperature control apparatus
1
Flat edged non-metal spatula
Cone Spindle and Certied Mineral Oil Viscosity Standard:
One of the following
2
:
- RC3-25-1 Cone Spindle with Fluid B41000
- RC3-50-1 Cone Spindle with Fluid B11000
- RC3-50-2 Cone Spindle with Fluid B41000
- RC3-75-1 Cone Spindle with Fluid B4900
- RC3-75-2 Cone Spindle with Fluid B4900
Rheo 3000 Applications Software loaded onto a PC (optional)
Reminders/Comments:
A calibration check can be performed with or without software.
The rheometer should always be allowed 10 minutes minimum to warm up.
Never lift your rheometer by the head, shaft, coupling element, or measuring element
coupled to the machine.
After the spindle has been lowered onto a sample, detach the spindle from the rheometer
head before raising the head.
Total time to perform a calibration check is approximately 50 minutes.
1
Temperature Control apparatus consists of one of the following: Peltier System, Water bath, Oil Bath or Electronic Heat
2
Calibration check using either an RC3-25-1 or RC3-25-2 is not advised. To achieve the best results, use RC3-50-1.
•
Start Up
Rheometer
Load the
Viscosity
Standard
Zero
Rheometer
Set the Gap
Calibration
Check in
Stand-alone
Mode
Calibration
Check
Using
Rheo2000
Figure B-1: Flow Chart for Calibration Check Procedure
AppendixBCalibrationCheckProcedure
B.1 Equipment
B.2 SetupPrrocedure
Vista de pagina 53
1 2 ... 49 50 51 52 53 54 55 56 57 58 59 60 61 62

Comentarios a estos manuales

Sin comentarios