Brookfield R/S CPS Rheometer Manual de usuario descargar pdf (Pagina 28)

BrookeldEngineeringLabs.,Inc. Page28 ManualNo.M08-218-B0212

This message will be displayed until the rst measuring point is reached and displayed.

100.5 ‰ 000.90 1/s

Eta: 1.728Pas

Tau: 1.572Pa

04s 20.7°C #01

Torque

Duration

Temperature

User dened value

Measurement results

Step (in single meas.

always 01)

If the torque is below 10‰ (scale is 0‰ to 1,000‰), the measurement results may not be

as accurate as desired. In this case the user dened parameters should be changed so the

torque is higher than 10%.,

If the display eld for the torque indicates: “Mlow!”, these values are below the range of

resolution of the rheometer.

If the temperature is not displayed, the measuring sensor is not connected and will show as

“1000.0°C” on the printout.

The display is updated with every new measuring point. The current measurement can be

cancelled at any time with the

key.

After a measurement is completed or if the

key is pressed, the display eld for Step

indicates “END” or “BREAK”. The display alternates at intervals of about four seconds

between the last displayed measuring point and information about the measurement:

Program end

Single measurement

Total time: 100s

Total #MP: 10

Reason for

break or end

Duration until

break or end

Type/name of

executed program

Number of measurement

points

Pressing the

key stops the alternating display and returns the user to the menu.

Note: The last selected program parameters remain in the memory even after switching

off the Rheometer.

VI.5.3 MAINMenu→ RunProgram

This function begins a user dened measurement program. With a Program Measurement,

the user can also set values as a linear function of time, such as D[s

-1

] = f(t). It is useful

to use “Run Program” when doing repeat measurements involving the same preset values

and the same measuring system. The user only needs to run the program rather than select

parameters each time they need to run the test. Four standard programs (and more optional

ones) may be dened. Section VI.6.2 Utilities → Edit Program describes how to prepare or

modify such a program.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 61 62

Comentarios a estos manuales

Sin comentarios

Brookfield R/S CPS Rheometer Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Brookfield R/S CPS Rheometer