Brookfield DV2+Pro Viscometer Manual de usuario descargar pdf (Pagina 33)

Brookeld Engineering Labs., Inc. Page 33 Manual No. M03-165-F0612

IV.3 Time Modes

TheTimeModesareprovidedtoallowmoreexibilitybyunattendedoperatingoftheviscometer

during data gathering. The last selected option (i.e. Time to Torque or Time to Stop) will be

highlightedwhenscrollingtothisoptionasshowninFigureIV-14:

DSETUP

DTIME TO TORQUE

Figure IV-14

A press of the OPTIONS/TAB key will “toggle” between the two available timed modes as shown

inFigureIV-15:

DSETUP

DTIME TO TORQUE

DSETUP

DTIME TO STOP

Figure IV-15

To enter the time for either of these options, press the ENTER/AUTORANGE key while the selected

optionisblinking.Let’sstartwithTimeToStop.

Note: These two modes are immediately executed when input is complete.

They do not return to the default screen until running is complete.

They can be stopped at any time by a press of the MOTOR ON/

OFF/ESCAPE key.

IV.3.1 Time to Stop

Onentry,theuserispresentedwiththefollowingscreendisplay:

TIMED STOP

SET MIN’S: 00 ↑↓

Figure IV-16

Note: If a time interval has already been set, the user may skip the time

interval input and go directly to the speed input screen by pressing

the ENTER/AUTORANGE key.

Using the UP and DOWN ARROW keys, the user enters a value for the minutes portion of the time

ramp.Thisvaluecanbeashighas59minutes.Whensatised,theuserpressestheOPTIONS/

TABkeyagaintoenterthesecondssettingdisplay:

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 100 101

Sin comentarios

Brookfield DV2+Pro Viscometer Manual de usuario Pagina 33