Brookfield DV-III Ultra Rheometer Manual de usuario descargar pdf (Pagina 72)

Brookeld Engineering Laboratories, Inc. Page 72 Manual No. M/98-211-B0104

Brookeld Engineering Laboratories, Inc. Page 72 Manual No. M98-211-E0912

IV.8.3 Data Page

Figure IV-60

Use this page to load, save, print, and export data taken with the DV-III Ultra Rheometer. The le

name (including path) of the data currently loaded is displayed at the top of the page.

The test parameters used to collect the data are displayed on the left of the page in the box labeled

“Parameters Used To Collect Data”.

Data is displayed on the right of the page in the box labeled “Data/Results”. All recorded data

points are displayed in the table.

Time Elapsed time since the beginning of the run cycle is shown here in units of

hours, minutes, seconds, and thousandths of seconds (H:MM:SS.SSS).

Data is taken at an interval equal to the Base Increment parameter.

% Torque This eld displays actual measured % Torque value

Delta % Torque This eld displays the difference between the current % Torque value and

the previous % Torque value. As the sample approaches its yield point,

the Delta % Torque should begin to decrease. If the Torque reduction for

the test is 100%, the yield point occurs when the % decrease in torque =

100.

Stress This eld displays the calculated stress for each data point. The nal Stress

value (i.e. the Stress at the yield point) is the resultant yield stress. See

Appendix D - Calculations - for the equation used to calculate stress.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 132 133

Sin comentarios

Brookfield DV-III Ultra Rheometer Manual de usuario Pagina 72